How do I install Classi Seal?

Step 1

Thoroughly roughen the contact surface with coarse sandpaper. Ensure the surface is clean and dry before proceeding. (Clean with water only. Other cleaning methods may leave residues that can affect adhesion.)

Step 2

Remove the backing paper approximately 100mm at a time. Position the butyl approximately 2mm above the top edge of the shower tray or bath. Press firmly into place by hand as you work around the tray or bath, maintaining the 2mm position throughout.

Step 3

Manipulate and widen the upstand at corners. Upstand is easy to manipulate by hand to fit into irregular internal corners which are not square, so as not to interfere with the tiling.

Step 4

Tiling can begin immediately. Classi Seal prevents leakage from around shower trays and baths caused by the inevitable shrinkage and movement within buildings.

Following tiling or wall panelling, finish with a Neutral Cure Sanitary Grade 100% Silicone.

Classi Seal is available in 2m, 2.5m, 3.2m, 4m to be used in an unbroken, continuous run.

Have more questions about our products?

Click here to see our FAQ.

Haven't found your answer?

Get in touch